Golf Mk4
Assembly overview - door handle and door lock |
1 - | Door lock |
q | The door lock can be removed only together with the assembly carrier. |
q | Removing and installing → Chapter |
2 - | Cable |
q | Lock release |
3 - | Retaining bracket |
q | Bolted and riveted to door lock |
q | Not supplied with door lock |
4 - | Multi-point socket head bolt |
q | This screw has been replaced by a Torx screw. The new tool was introduced as a result. |
q | Socket driver -T10011- |
q | Socket driver -T10072- |
q | Loosening this screw releases the lock cylinder housing → Item, which can then be pulled out of bearing plate → Item. |
q | Bolt → Item should not be screwed in if the lock cylinder housing is not in place. The retaining ring could fall into the door. |
5 - | Bearing plate |
q | Removing: |
Door handle, lock cylinder housing and assembly carrier removed |
– | Remove cross-head screw → Item, push bearing plate backwards slightly and take out of door. |
6 - | Cross-head screw |
7 - | Key |
q | With remote control (non-folding type) |
q | Renewing battery ► 04.01 → Chapter |
8 - | Key |
q | With remote control (folding type) |
q | Renewing battery ► 04.01 → Chapter |
q | Renewing battery 05.01 ► → Chapter |
q | Adapting new or additional key to remote control → Chapter. |
9 - | Door handle with backing plate |
q | Removing and installing → Chapter |
10 - | Cap |
11 - | Lock cylinder housing |
q | Removing → Chapter |
q | Lock cylinder is not available as a single replacement part |
12 - | Backing plate |