Golf Mk4
| Assembly overview - door handle and door lock |
| 1 - | Door lock |
| q | The door lock can be removed only together with the assembly carrier. |
| q | Removing and installing → Chapter |
| 2 - | Cable |
| q | Lock release |
| 3 - | Retaining bracket |
| q | Bolted and riveted to door lock |
| q | Not supplied with door lock |
| 4 - | Multi-point socket head bolt |
| q | This screw has been replaced by a Torx screw. The new tool was introduced as a result. |
| q | Socket driver -T10011- |
| q | Socket driver -T10072- |
| q | Loosening this screw releases the lock cylinder housing → Item, which can then be pulled out of bearing plate → Item. |
| q | Bolt → Item should not be screwed in if the lock cylinder housing is not in place. The retaining ring could fall into the door. |
| 5 - | Bearing plate |
| q | Removing: |
| Door handle, lock cylinder housing and assembly carrier removed |
| – | Remove cross-head screw → Item, push bearing plate backwards slightly and take out of door. |
| 6 - | Cross-head screw |
| 7 - | Key |
| q | With remote control (non-folding type) |
| q | Renewing battery ► 04.01 → Chapter |
| 8 - | Key |
| q | With remote control (folding type) |
| q | Renewing battery ► 04.01 → Chapter |
| q | Renewing battery 05.01 ► → Chapter |
| q | Adapting new or additional key to remote control → Chapter. |
| 9 - | Door handle with backing plate |
| q | Removing and installing → Chapter |
| 10 - | Cap |
| 11 - | Lock cylinder housing |
| q | Removing → Chapter |
| q | Lock cylinder is not available as a single replacement part |
| 12 - | Backing plate |
